What Is The Preparation Of Fire Fighting Motorcycle Before The Fire

When various fires occur, when there is a big traffic accident that needs rescue; when someone is trapped in a certain place; even when the people lack water, they will see it in red. In order to reduce the threat to people's lives and property to a greater extent and to affect the rescue time in the remote areas, the enterprises and township departments are actively preparing for various types of fire engines to improve fire safety. The role of the car is getting more and more attention.

Fire trucks are deployed in areas such as forests, mining areas, and large farms where there is a slight fire that may cause a major fire. In the event of a fire in these areas, if the fire does not spread very quickly, it will form a large area of combustion, and the consequences will be disastrous. Therefore, in the event of a fire, it is very important to be able to block the spread of the fire and reduce the loss in time. If you need to do the following steps before the fire occurs, you can extinguish the fire more promptly.

Step 1: Connect the Fire Fighting Motorcycle suction hose to the fire pump inlet. (Pay attention to whether the connection is connected when the connection is made, so as to prevent the water from leaking due to air leakage)

Step 2: Close the pump inlet valve.

Step 3: Hang up the power take-off. The power take-off switch separates the oil brake and the steam brake; (note that when the power is pulled, first step on the clutch to open the switch, slowly loosen the clutch)

Step 4: Open the vacuum pump, open the vacuum pump exhaust valve at the same time, and observe the reading of the vacuum pump. Generally, when the vacuum reaches 0.02, it can enter the tank. When the vacuum is expressed to 0.02 or above, the vacuum pump exhaust valve is closed and the vacuum pump is turned off. . (If the vacuum gauge does not move, it proves that there is a leak in some place, and then carefully check the place where the leak is found)

Step 5: After the water is full, remove the power take-off, close the inlet valve, open the vacuum in the position of the fire pump drain valve, remove the suction pipe, and cover the cover.